TOOLS: 

• Paint stirrer or wide stick

• 4-5mm short pile roller (tiled floors)

• 8 to 12mm pile roller (wooden floors) 

• Round edeged paint brush (for angles, corners & finishes

PREPARATION: 

PREPARATION of the surface is ESSENTIAL WASH the surface with a soda-based or sugar soap (alkaline) cleaner. 

• On laminate and varnished or painted wood in good condition : wash, rinse and allow to dry. Sand (240 grit) and remove dust. 

• On oak and raw chestnut: apply a suitable undercoat to block the tannins.

• On raw tiled floor: wash, insist on groutings, rinse and allow to dry. 

• On tiled floor already painted in good condition: wash, rinse thoroughly and allow to dry. Sand (240 grit) and remove dust.

• On tiled floor already painted or partially worn: Sand with sandpaper (60 then 120 grit) to return to the original surface. Remove dust, wash, rinse and allow to dry.

APPLICATION

Apply the paint at room temperature between 12 and 25°C and avoid draughts. 

1. Empty the additive (the sachet that is placed under the lid of the pack) into the paint. Stir the paint for 5 minutes, working around the bottom of the tin with a wide stick to mix it well. 

2. Start with the edge of the room with the brush and continue with the roller. Work on small surfaces. Apply from one end to the other. Follow with successive cross strokes. Do not start 2nd coat while it's still drying. Leave to dry for 3h and apply a 2nd coat in the same way. A 3rd coat may be required depending on the surface and colour. 

Once the sachet has been added, the mixture must be used within 10 days to maintain optimal adhesion and performance.

V33 TIPS: 

To clean your painted surfaces, use a gentle detergent and a mop. Optimum product performance and adhesion is achieved after 20 days from application. Treat the surface gently, avoiding direct impact, abrasion, staining or cleaning, for the first 20 days after application.